Fiberglass mesh

Fiberglass mesh has tensile strength, small elongation (3%), high elasticity and rigidity, large shock resistance, good chemical resistance, small water absorbent, the scale stability, heat resistance are good, low cost, not easy burn and forming glassy beads at high temperature. Black silicone coated fiber glass mesh fabric is also offered by us.

Alkali-resistant fiberglass mesh has excellent properties including water-resistance, alkali-resistance, flexibility, softness and resistance to aging. It is widely used in reinforcing walls, natural marble, plaster board, artificial stone materials and exterior insulation finishing system.

When you’re taping sheetrock seams, it’s imperative that you apply an even coat of drywall mud for a smooth finish. Fiberglass mesh is easier to use than drywall paper tape and it resists bubbling. Although paper tape is quicker if you’re a professional, most do-it-yourself will find that fiber glass mesh offers a workable substitute.
Prepare your installed drywall sheets by aligning the edges as tightly as possible before beginning the taping process. Wipe the bare seams down with a tack cloth to remove drywall dust.
Unroll one end of the fiberglass mesh and determine which side is sticky. Begin at the top and stick only the top edge of the mesh on the seam. Leave a 1-inch space from the ceiling. Carefully, unroll the mesh as you hold it outwards from the wall. If you allow it to touch too soon, it will adhere and make it difficult to apply in a straight line.
Hold the bottom edge of the unrolled fiberglass mesh at the bottom of the seam. While watching to make sure the seam is in the middle of the mesh, lower it until it meets the wall.
Cut the bottom edge of the mesh and use your hands to gently smooth the mesh from the center to each end, ensuring that no wrinkles form. Scoop some prepared drywall mud into a taping bucket with the 6-inch taping knife. Using the same knife, pick up a small portion of the mud, approximately one-half cup, and put it on the fiberglass mesh, smoothing as you go. Since this is the first coat, use some pressure to force the mud through the holes in the mesh and into the seam. Cover the entire seam with an even coat of mud.
Follow up immediately, while the mud is still soft, with the 10-inch taping trowel. Pull the trowel along the seam carefully, smoothing the mud and leveling it with the surface of the wall. Make sure you smooth out any crown on the seam.
Allow the mud to dry, sand off rough edges or lumps and apply two more very thin coats. Sand after the last coat is dry and paint or texture your walls.

When you purchase fiberglass mesh,first,need to confirm which type fiberglass mesh you want,because so many series of fiberglass mesh,so choose the suitable one for yourself,please also note the different material! We have Alkali-resistant fiberglass mesh,GRC reinforced fiberglass mesh,Self-Adhesive fiberglass mesh tape and Woven roving fabrics.

Second,client must choose a professional fiberglass mesh company,comparing from four points,professional,serivce,technology,honest.A responsible enterprise will assure the material and delivery time,do everything carefully.

At last,hope you have a good business.

 


Post time: Sep-11-2019
WhatsApp Online Chat !